Description
Overview
OmniGrip is a flexible, lightweight premixed adhesive for interior tile and stone work. Its sag- and slip-resistant formula holds wall tile while setting and is formulated for 33% less shrinkage than traditional adhesives, with small-format tile up to 12 inches recommended.
Features
- Lightweight formulation weighs approximately 33% less than traditional adhesives.
- High flexibility and bond strength for compatible tile assemblies.
- Designed for intermittent water exposure on tub surrounds and shower walls.
Specifications
- Sizes: 1 gallon or 3.5 gallons
- Recommended tile size: Up to 12 in.; up to 15 in. requires substantially longer drying
- Standard: Exceeds ANSI A136.1 Type I
- 3/16 Ć 5/32 in. V-notch: 40ā60 sq. ft. per gallon; tile up to 6 in.
- 1/4 in. square notch: 15ā25 sq. ft. per gallon; tile up to 12 in.
- 1/4 Ć 3/8 Ć 1/4 in. square notch: 10ā14 sq. ft. per gallon; tile up to 15 in.
Size Options
- Gallon
- 3.5 Gallon
Downloads
Applications
Select OmniGrip for interior walls, floors and countertops where sag resistance and a lightweight adhesive are useful. Concrete, masonry and plaster must be properly prepared; gypsum wallboard and exterior-grade plywood have dry-area restrictions.
Selection and Use
- A larger tile allowance does not mean rapid drying: dense tile, high humidity and temperatures below 60Ā°F can greatly extend the minimum 24-hour wait before grouting.
- Do not use on shower floors, in steam rooms, underwater or over radiant heating.
- Do not bond over waterproofing membranes, coated backerboard or prohibited non-porous surfaces. Have CUSTOM verify preparation for existing tile or laminate rather than assuming every existing finish is suitable.
- Not for resin-backed or moisture-sensitive stone, transparent glass, translucent stone, ungauged stone or gauged stone thicker than 3/8 in.
- Use the coverage estimates to plan quantity, then check actual contact behind tile. Choose a cement mortar if the installation cannot provide acceptable adhesive drying.
