Aqua Mix SameDay Grout Sealer, 15 oz.

Aqua Mix
(No reviews yet)
Current Stock:

Sold Out

Out of Stock

Aqua Mix SameDay Grout Sealer

Confused by Sealers? Take a look here: Sealer Buying Guide

Aqua Mix SameDay Grout Sealer is a non-flammable, no-sheen, natural look formula that is water-based and allows moisture vapor transmission. Easy-to-use aerosol application is a great and effective way to seal grout in your kitchen or bathroom. It can be applied as soon as 2 hours after grouting - making sealing an efficient, economical process and is equally effective on new and exisiting grout. Recommended for use on cementitious sanded and unsanded porous grout joint for ceramic tile installations.



1.) Read entire label before using.


2.) SHAKE WELL before using.


3.) For new installations, sealer can be applied as soon as 2 hours after grouting.


4.) Grout joints must be clean, dry, and free of existing sealers or coatings.


5.) Invert can and point nozzle toward the grout, keeping nozzle 10”-16” (25 cm to 41 cm) from the surface.


6.) Depress nozzle and spray along grout lines. Some sealer will get on the tile, which will evaporate without the need to wipe dry. NOTE: Be sure any sealer that does not penetrate surface is removed from surface within 5 mminutes of application using absorbent paper or cotton towels.


7.) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats. Be careful not to directly rub fresh grout if sealer is applied same day as grout.


8.) After 2 hours conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test.


9.) Ready for surface traffic 2 hours after final coat. Keep area dry for 12 hours. Achieves full cure in 24 hours.


10) May be reapplied as needed to grout joints that are clean.


For Pre-Grouting Application:

Apply over clean stone or tile a minimum of 2 hours prior to grouting - follow application procedures above.



• Do not allow sealer to come in contact with any non-recommended surface.

• May slightly lighten or darken some surfaces.

• Sealer will not prevent surface wear or etching from acids or caustic chemicals.


It covers approximately 300 to 500 sq. ft. (28 m2 to 46 m2) per 15-oz. can (444 ml), depending on size and porosity of grout joint, temperature, humidity, and method of application.