Description
Overview
Glaze ’N Seal Wet Look Green is a crystal-clear acrylic lacquer that deepens the appearance of decorative concrete, masonry and porous tile while leaving a high-gloss finish. Its penetrating formula bonds to suitable porous surfaces for indoor or outdoor sealing.
Features
- Non-yellowing, high-gloss wet-look appearance.
- Fast-drying, recoatable finish.
- Can be applied with a natural-bristle brush, lamb’s wool applicator or solvent-resistant low-pressure sprayer.
Specifications
- Type: Acrylic concrete and masonry lacquer
- Appearance: Clear, high gloss; wet-look enhancement
- First-coat coverage: Approximately 100–400 sq. ft. per gallon, depending on porosity
- Coats: 2–4 thin coats, depending on surface porosity
- Recoat interval: 1–3 hours or until dry to the touch, per linked guide
Size Options
- Quart
- Gallon
- 5 Gallon
Downloads
- Glaze 'N Seal "Wet Look" Green Lacquer Data Sheet
- Glaze 'N Seal "Wet Look" Green Lacquer Safety Data Sheet
Applications
Use on suitable porous decorative concrete, pavers, masonry and tile where a visible glossy enhancement is desired, including driveways, patios and garage floors. Test a small area first to confirm both appearance and absorption.
Selection and Use
- Do not use on dense or presealed surfaces such as glazed tile, quarry tile, marble, dense brick, dense slate or polished granite.
- Remove efflorescence, dirt, oil, wax, grease and defective coatings. Neutralize prior acid cleaning and allow the surface to dry thoroughly; the linked guide specifies 72 hours after water cleaning.
- Apply thin, even coats without puddling. Avoid direct warm sunlight and use only with adequate ventilation.
- Do not use where hydrostatic pressure is likely, including poor-drainage conditions. Sealed surfaces may be slippery when wet.
- Read the product label and linked safety information before using this petroleum-distillate-containing lacquer.
