Aqua Mix Pro-Solv, Gallon

Aqua Mix
(1 review)
Current Stock:

Sold Out

Out of Stock
Aqua Mix Pro-Solv, Gallon


Aqua Mix Pro-Solv is an economical solvent-based, penetrating sealer formulated to resist stains, especially in food preparation and serving areas. It provides a below the surface, no sheen, natural look on all natural stone such as granite, limestone, marble, slate, and travertine, porcelain, quarry, saltillo, terra cotta, cement pavers, masonry surfaces, and other porous tile and grout. Great for interior and exterior applications.

1) Read entire label before using.
2) SHAKE WELL before using.
3) For new installations sealer can be applied as soon as 48 hours after grouting.
4) Surface must be clean, dry, and free of existing sealers or coatings.
5) Apply using a sponge, brush, paint pad, cotton towel, or sprayer. NOTE: Be sure any sealer that does not penetrate surface is polished dry off surface within 5 minutes of each application using absorbent paper or cotton towels.
6) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats.
7) 2 hours after final coat conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test.
8) Ready for surface traffic in 2 hours after final coat. Keep area dry for 12 hours. Achieves a full cure in 24 hours.
9) Clean applicator tools with mineral spirits after each use.
Pre-Grouting Application:

Apply over clean stone or tile a minimum of 2 hours prior to grouting - follow application procedures above.

• Do not allow product to come in contact with any non-recommended surface.
• May slightly lighten or darken some stone surfaces.
• Sealer will not prevent surface wear or etching from acids or caustic chemicals.
It covers approximately 300 to 1,500 sq. ft. (28 m2 to 140 m2) per coat per gallon (3.785 L), depending on type of stone or tile, porosity and texture of surface, temperature, humidity, and method of application.


  • 5
    Excellent Floor Sealer

    Posted by Scott

    Looked all over for this product locally and couldn't find it. This website had the best price that I could find online. The sealer works great even though I was worried at first because it brought out a "yellowish" color in the marble when applied. However, this went away when the product dried. If you use a sponge to apply you really don't need a whole lot of this stuff. I only used maybe 1/4 gallon for around 175 ft^2.