Aqua Mix Penetrating Sealer is an economical, no-sheen, natural-look, water-based, penetrating sealer designed to resist stains. You can also use it as a pre-grouting sealer and it allows moisture vapor transmission. It's also a good grout sealer and is effective for interior and exterior applications.

Aqua Mix Penetrating Sealer is recommended for use on all natural stone (such as granite, limestone, marble, slate, and travertine.), porcelain, quarry, saltillo, terra cotta, cement pavers, masonry surfaces, and other porous tile and grout where a natural look is desired.


Coverage:

It covers approximately 300 to 1,000 sq. ft. (30 m2 to 95 m2) per coat per gallon (3.785 L), depending on type of stone or tile, porosity and texture of surface, temperature, humidity, and method of application.


Application:

1) Read entire label before using.

2) For new installations, sealer can be applied as soon as 48 hours after grouting.

3) Surface must be clean, dry, and free of existing sealers or coatings.

4) Apply using a sponge, brush, paint pad, cotton towel, or sprayer. NOTE: Be sure any sealer that does not penetrate surface is polished dry off surface within 5 minutes of each application using absorbent paper or cotton towels.

5) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats.

6) 2 hours after final coat conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test.

7) Ready for surface traffic in 2 hours after final coat. Keep area dry for at least 12 hours. Achieves a full cure in 24 hours.

8) Clean applicator tools with water after each use.


For Pre-Grouting Application:

Apply over clean stone or tile a minimum of 2 hours prior to grouting - follow application procedures above.


Limitations:

• Do not allow product to come in contact with any non-recommended surface.
• If product is allowed to dry on surface, a white film may form.
• If this occurs, scrub surface with water and a white nylon pad.
• Sealer will not prevent surface wear or etching from acids or caustic chemicals.

Note: Aqua Mix Ultra-Solv™ or Sealer’s Choice™ Gold are recommended in place of Penetrating Sealer in food preparation areas or where maximum stain protection is required.