FREE SHIPPING ON QUALIFYING ORDERS
StoneTech Oil Stain Remover
STONETECH Oil Stain Remover is the ready-to-use, problem solving solution to removing deep-set oil-based stains from natural stone, masonry and grout. Just stir, apply and wait to pull out tough, deep-set organic oil and grease stains and avoid costly restoration fees.
Features and Benefits:
- Pulls out deep, set-in oil stains
- Leaves no residue
- Will not discolor stone
- Easy to use
Where to Use:
Natural stone such as marble, granite, limestone, travertine, slate & sandstone. Grout for ceramic and porcelain tile. Masonry and concrete.
Available Size and Coverage:
Pint Size - will cover ½-1 sq. ft. of the surface at 1/4" thickness.
Directions:
Always test in a small inconspicuous area to determine that the desired results will be achieved. Make sure the surface is clean, dry, and free of waxes and coatings.
1. Using a plastic or wood spatula, stir thoroughly to mix the paste.
2. Apply a 1/4” thick layer of paste to the stain. Ensure that the paste extends at least 1"-2" beyond the edge of the stain.
3. Do not cover.
4. Allow 48-72 hours for the paste to completely dry to a powder.
5. Remove powder and discard.
6. Allow solvent to completely dry from the stone.
7. If the stain is not completely gone after drying, repeat the process.
8. Clean up residue and tools with mineral spirits.
9. Reseal cleaned area. Note: Above instructions are for reference purposes only. Please follow label directions on the back of the actual product.
StoneTech Oil Stain Remover Technical Data Sheet
StoneTech Oil Stain Remover Safety Sheet
- 30.43400:
- ST322-0616-11
Related Products
Reviews
-
Crazy GOOD
I left some pulled pork on my granite and didn't know it was not sealed. It took about 3 days and it was COMPLETELY PULLED OUT of the stone. I hope to properly seal and hopefully not run into this problem again.