Diamax Super Cyclone Electroplated Marble Blade

Overview

The Super Cyclone Electroplated Marble Blade is designed for hard marble, porcelain and engineered-glass composite materials. Vortex side protection supports clean 90-degree cuts, and the blade is thick enough for quad-adapter applications.

Features

• Electroplated cutting design for the listed hard and composite materials.
• Vortex side protection for cleaner cut edges.
• Wet or dry operation.

Specifications

• Diameters offered: 4, 4.5, 5, 6 and 7 inches

Size Options

• 4"
• 4.5"
• 5"
• 6"
• 7"

EMBSL40

• Size: 4"
• Max RPM: 15,000
• Arbor: 5/8" - 7/8" + 22mm
• Wet / Dry Cutting: Wet / Dry

EMBSL45

• Size: 4.5"
• Max RPM: 13,300
• Arbor: 5/8" - 7/8" + 22mm
• Wet / Dry Cutting: Wet / Dry

EMBSL50

• Size: 5"
• Max RPM: 12,000
• Arbor: 5/8" - 7/8" + 22mm
• Wet / Dry Cutting: Wet / Dry

EMBSL60

• Size: 6"
• Max RPM: 10,185
• Arbor: 5/8" – 7/8" + 20 mm
• Wet / Dry Cutting: Wet / Dry

EMBSL70

• Size: 7"
• Max RPM: 8,730
• Arbor: 5/8" - DKO
• Wet / Dry Cutting: Wet / Dry

Applications

Use this blade for straight cutting in marble, porcelain or engineered-glass composites. Choose the diameter and arbor arrangement for the machine; the 7-inch version uses a 5/8-inch–DKO configuration rather than the smaller models’ multi-size arbor arrangement.

Selection and Use

• Match the model-specific maximum RPM below rather than using one speed for the whole range.
• Quad-adapter capability describes the blade design; no adapter is stated as included on this listing.
• This is the electroplated marble blade, not the separately offered porcelain turbo-mesh blade.