Description
Overview
Bonstone Duropoxi is a two-part, non-sag epoxy for bonding stone, concrete and masonry. Its gel body stays in place for structural patching and setting work, including suitable exterior applications.
Features
- 100% solids epoxy system.
- Non-sag consistency for controlled placement.
- Chemical-resistant cured adhesive for suitable service conditions.
What's Included
- 1 quart Duropoxi Part A.
- 1 quart Duropoxi Part B.
Specifications
- Kit total: 2 quarts
- Mix ratio: 1 part A to 1 part B by volume
- Pot life at 75°F: 20 minutes
- Initial set at 75°F: 1 hour
- Full cure at 75°F: Within 24 hours
- Minimum component and substrate temperature: 55°F
- Shelf life: Approximately 1 year unopened in a dry area at 75°F
Downloads
Applications
For bonding stone to stone or compatible construction materials, structural concrete patching, and setting stone pavers or tiles. It is useful where a non-sag adhesive must remain in a vertical joint.
Selection and Use
- Bond only dry, dust-free surfaces without oil, grease or coatings. Measure equal volumes and mix to a uniform blend.
- Mix only an amount that can be placed promptly; warmer conditions shorten the available time. Do not stress the joint before full cure.
- Sunlight can yellow the epoxy. Review that appearance limitation before choosing it for an exposed joint, and follow the safety sheet for cleanup.
