Description
StoneTech Stone, Tile & Grout Sealer
StoneTech Stone, Tile & Grout Sealer will properly treat your natural stone with a protective sealer to prevent water, oils or other liquids that can easily penetrate the stone, leaving behind unwanted stains. This new, advanced water-based formula bonds with stone for improved wear resistance. Its penetrating microbond protection preserves the "natural" look and makes cleaning stone easier.
StoneTech Stone, Tile & Grout Sealer can be used on natural stone such as marble, granite, limestone, slate & travertine and for interior & exterior projects!
Features and Benefits:
- Advanced penetrating microbond protection
- Standard protection against most stains
- Makes cleaning stone easier
- Preserves natural look
- Water-based, low-solids coating
- Interior & exterior
Directions:
Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings. Surface temperature should be between 50°F and 80°F. Ensure that the area is well-ventilated during application and until the surface is dry to the touch. Keep children and pets out of the area until foot traffic resumes.
- Mask off and protect any baseboards or adjacent areas to avoid splashing sealer onto surfaces not intended to be treated.
- Sealer may be applied to damp surfaces one hour after standing water has been removed.
- Liberally apply an even coat using a paint pad, roller or brush.
- Allow sealer to penetrate the surface for 15-30 minutes. During this time, distribute excess over entire area to ensure even penetration. Remove excess sealer by wiping entire surface thoroughly with clean, dry towels.
- A second coat may be needed for porous, absorbent surfaces and should be applied 30-40 minutes after initial application as directed in steps 3-4.
- Wipe entire surface with clean dry towels to remove any excess sealer. If needed to remove residue, reapply a thin coat of sealer, allow to dwell for 2-3 minutes, agitate with a white nylon pad and dry thoroughly with clean, dry towels.
- A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. If foot traffic must resume sooner, cover the floor with red rosin paper to protect it until full cure has been achieved. Red rosin paper is not needed to apply second coat.
- Clean equipment with water.
Sizes and Coverage:
- Quart: 225 sq. ft.
- Gallon: 900 sq. ft.
StoneTech Stone, Tile & Grout Sealer Product Data Sheet
StoneTech Stone, Tile & Grout Sealer Safety Data Sheet
