Description
Overview
The GRABO RK13001 Type A1 foam-rubber seal replaces a worn or damaged sealing element on a compatible GRABO lifter. The high-friction, closed-cell construction forms the contact area between the tool and the material; replacing a worn seal helps restore the tool’s ability to maintain its intended vacuum.
Features
- Hand-replaceable seal for routine maintenance.
- Closed-cell rubber construction with black and red material components.
- Replacement for an existing seal, not an upgrade to the tool’s rated lifting capacity.
Specifications
- Part number: RK13001; Type A1
- Dimensions: 11.5 × 6.9 × 0.7 in / 293 × 175 × 19 mm
- Black material: SBR rubber foam sponge
- Black density / hardness: 170 kg/m³ / Shore C approximately 10 ±2
- Black tearing pressure: Manufacturer-listed 1,800 psi
- Black compression to 25% size: 8.5 psi
- Black water absorption: ≤5%
- Black shrinkage test: ≤20% after 24 hours at 160°F / 70°C
- Red material: Silicone foam
- Red density / hardness: 650 kg/m³ / Shore C 55 ±5
- Red water absorption: ≤4%
- Storage: Room temperature
Applications
Use when the existing Type A1 seal is worn, damaged or no longer maintaining the expected seal. Confirm the replacement type against the tool before fitting it; a fresh seal cannot compensate for an unsuitable surface or an excessive load.
Selection and Use
- Inspect the contact surface and seal before lifting and verify vacuum after replacement.
- Material test values describe the seal components, not a working-load rating for the lifter.
- Store the spare at room temperature and protect its sealing surfaces from damage.
